:o Loaded factory set and then the current bin following the posted set up guide. Also read here and there. Funny, it is way different from the older CS versions.
First 91 came up and the channels. However, I wanted to scan 119 and 110 and started playing with the positioner since I have a motor. I did factory setting, loaded a couple of times hoping that I would go back where I started, NO LUCK. By the way quality is zero everywhere. No channels.
Anybody in Northern California has a good setting for this....or anybody. CS4000/5000 easier than this. Perhaps it is me. I am lost. Pls help.
Thank you in advance..