What programs to Install

1) vbrun60sp5.exe
2) winvu!2007
3) ird2pc

-In winvu!2007, hit your Caps Lock (located on keyboard), convert your IRD number and Cam to Hex (use windows calculator in windows and set view to scientific).

Here's a quick note about the Hex conversion

Load up the calculator in Windows. Click "View" and change to "Scientific"

If the IRD number is R00-1234-1234-XX, put the number 12341234 in the calculator. Then, click the HEX button to convert the number to HEX

In the excample above, 12341234 is BC4FF2, therefore, you would enter 00BC4FF2 as your IRD number. You may need to add 1 or 2 zeros to the start of your HEX number so that it is 8 digits long.

Repeat for Smartcard using S04-1234-1234-XX, enter 412341234 in the the calculator and then click HEX to get the HEX number. (don't use that smartcard number, it's just an example).

-Enter Boxkey
-Set Zp-Tx-SID (90210-AST-0101)
-select COM 1 and set speed to: 115200
-click on: auto-roll and ird2pc (make sure they are check marked)

-Set Windows Control Panel
-System>Device manager>(COM&LPT) in the sub menu select (COM 1) and click twice>Port settings>(starting from the top)115200-8-NONE-1-NONE, if these settings are not good enough play around with the [Advance]

3) ird2pc

-Here is what the Readme file contains

Normal Avr3 users wanting to apply ird2pc
1) Load Jeepers
2) Select IRD2PC for Program
3) Click Full Monty
4) Enjoy Emulation!
=========================================
Avr6 users wanting to apply ird2pc
(avr3's with 24lc eeprom or one with 10-12 jumped)
1) Load Jeepers
2) Select IRD2PCv2 for Program
3) Click Full Monty
4) Enjoy Emulation!

* Note
(ird2pcv2.pfg supports the "read" option however ird2pc.pfg does not)
____________________
What files to copy

1) EMM.dll
2) Mscomm32.ocx
____________________
NOTE: These 2 file must be copied to your Windows System directory

Example: C:\windows\system
____________________

Hardware

-AVR 3 Non auto-roll or auto
-Late P2 computer or Pentium 3
NOTE: A slower computer needs more RAM

-Dish Emu cable

Platform

-windows 95-98-98SE-and up
-I used a 2.5 Gig Hard disk with 98SE

Here's how to make a Dish EMU cable http://clipart.tripod.ca/schematic__AVR_to_PC_EMU_Cable.jpg

If you plan to build a 0 cost site to host schematics, pictures, etc, Join Tripod (Limited 12 MB)

You don't have to use a valid address, make one up. (www.tripod.ca)

Winvu2007 is down. You will need to use Winvu2008 or Chinaman RamCemu V2.

NOTE: Chinaman RamCemu V2 runs off the Ram, it's used as a Startup Disk.