I've just got myself an avr6 board, but for some reason it doesn't work. I have dp301 receiver and A2013 card. Software that I used to program avr6 board is jeepers 2.0.8 (I'm trying to make it work as married-sub, since I do have a subscription). Everything works just fine up to the point when I actually try to use it. My receiver turns on for a short period of time (a few seconds), gives me a message "trying to acquire satellite signal", and then it goes off for a few second. And then it does it all over and over again. I tried to check system info while it's on, and it looks like that it can't get a CAM number (all digits are 0s).

Any help would be appreciated.

I'm sorry, could you please be a little bit more specific? All I could find was references to a fact that avr would require some simple modification, and couple of schematics. Is this what I need? What do I do with these schematics? Where do I connect them? I apologize for these probably stupid questions, but I really have no idea.

Thanks!