i downloed the new file and i downlaoded all the chanels. i have 121 110 119 and 91 . then i have problem with frzzing so reebot the mangum when turn on i lost many chaels on bev and dn. also many dn chanles number change to bev numbers .when i click the change number chanles it saying scrambled chanels so anybody have same problem and how to solve please post here tahnks

Best way to fix this is to go back to 143B, it's been flawless for me the last 5 days. Good Luck!!

i downloed the new file and i downlaoded all the chanels. i have 121 110 119 and 91 . then i have problem with frzzing so reebot the mangum when turn on i lost many chaels on bev and dn. also many dn chanles number change to bev numbers .when i click the change number chanles it saying scrambled chanels so anybody have same problem and how to solve please post here tahnks
Seen that too with v1.45. It will require a Factory Default, re-setup, and re-scan for channels to fully fix. Somewhat better after re-installing v1.45 over itself, but it took a Factory Default to get everything back to normal. And even then, it was a short-term improvement.

If I were you, I'd try the v1.43b as suggested with a Factory Default.

Hi, I restored my Magnum to factory default then added the bin 143b and did a channel search for the echostar 8.6 satellite. I'm having a hard time adding the 7 echostar satellite. Any tips would be greatly appreciated as I have the 110 up and running but not the 119. I found a post on set-up and restored the satellite then scanned the channels. Thanks for your input.

Hi, I restored my Magnum to factory default then added the bin 143b and did a channel search for the echostar 8.6 satellite. I'm having a hard time adding the 7 echostar satellite. Any tips would be greatly appreciated as I have the 110 up and running but not the 119.


I'm sure you would get some help if you open a new post and posted some more info about your setup. With that said, using Diseq switch? make sure you have the proper input selected...

tony

You should go ahead and set up all your satellites before starting a scan. Go to Factory Default and choose "Factory Satellite Restore" and set up for Echo 7. This is where you add satellites to your list. After you get them all set there you can then go to "Setup Satellite" and refine the settings before starting the scan.