SKUNKER
12-07-2006, 03:00 PM
c/p found at f2atv posted by scodez
I've noticed that every once in a while people post that they are having problems getting 7-day EPG with DN.
To get 7-day EPG, leave your receiver on one of the following channels for at least 10 minutes:
146, 239, 418, 424, 427, 436, 572, 5814
The "EEPG" is located on 119W, so you must be pointed to this satellite in order to get these channels and 7-day EPG.
Q. How do I find the channels that populate the 7-day EPG?
A. Go to http://www.lyngsat.com/packages/dish119.html and search for "EEPG". The channels are grouped by transponder. Tune into any channel on the transponder that the EEPG channel is on (currently TP18), and you will receive 7-day EPG.
Q. How come the guide isn't populating fully? Or how come it's only populating channels on 110W but not 119W?
A. Press Menu -> Channel Manager -> Timer -> Timer Setup, and check your time settings. If they are correct, just press Exit, and your guide should populate fully. For some reason, I need to do this after a factory reset or bin upgrade.
Reply With Quote
I've noticed that every once in a while people post that they are having problems getting 7-day EPG with DN.
To get 7-day EPG, leave your receiver on one of the following channels for at least 10 minutes:
146, 239, 418, 424, 427, 436, 572, 5814
The "EEPG" is located on 119W, so you must be pointed to this satellite in order to get these channels and 7-day EPG.
Q. How do I find the channels that populate the 7-day EPG?
A. Go to http://www.lyngsat.com/packages/dish119.html and search for "EEPG". The channels are grouped by transponder. Tune into any channel on the transponder that the EEPG channel is on (currently TP18), and you will receive 7-day EPG.
Q. How come the guide isn't populating fully? Or how come it's only populating channels on 110W but not 119W?
A. Press Menu -> Channel Manager -> Timer -> Timer Setup, and check your time settings. If they are correct, just press Exit, and your guide should populate fully. For some reason, I need to do this after a factory reset or bin upgrade.
Reply With Quote