:huh: Does any one else have their locals comming and going like me?
I'm have been testing rom 102/Hack's 7.2 codespace blocker on my 4900.
I had all my locals, then a few days later, they were gone. When I noticed it the first time, they were gone about all night, then they returned in the early morning hours. I had them for about 5 days, now they are gone again!
I have been testing some LNB's, dishes, and such, but I haven't done any futher testing on the receiver and/or card. After I tested the other equipment, I hooked my sat. feed back up, which is Dish 500 w/Legacy Quad, and a single dish for 61.5 running into a SW21. I ran the check switch, and all 3 birds are showing up with all odds and evens.
Is Dish Network, re-mapping the locals every so often, or what?
I have turned off my receiver, in hopes that it would update(local channel info.), but my locals are still gone!
Any advice or an answer to this, would be appreciated!
Thanks,
stinkbomb1020:beer: :beer:

I guess loosing the locals was related to doing the testing of the different LNB's on another Dish. After turning my receiver off at 6:30am, and turning it back on about 6:55am, my locals returned! I assume all it needed was time to update that particular info., again. Any ways...all is good...so far!
stinkbomb1020

I noticed the same problem... Locals go blank momentarily and come back.
It only last a few seconds.
:wacko:

This usually happens when you have to many tiers on your bin. Try getting rid of a few and see if that helps.

if it happens again,check for them in the 8000-9000,,could be some kinnda remap problem,,or as dssjacker said above,,u are over loading the ird.

It's all good, as of now. I used Hack Kid's 7.2 bin, and all I modified and inputed was my local channel info., and time zone. I didn't use any personal tiers or such. Like I said earlier, it must had been related to me testing the other sat. lnb's. I guess, when I did the signal and switch testing, somehow that wipped out my local channel info. on the receiver, and all my receiver needed was to be turned off for a while to update the info. from the cam back to the receiver. I know...sounds fishy, but my locals have been back all day and night. I haven't lost them again...not yet anyway! Thanks guys for your advice and help.
stinkbomb1020