orasat
09-19-2006, 06:48 PM
Step 1
Using radioshack's "USB to null modem" cable and original null modem cable which comes with DM , I hooked up laptop to DM.
Via windows hyperterminal, I went to Dreambox ADVANCED SETUP UTILITY and changed Network type to "Manual"
and
changed DM's IP to 192.168.0.24 In the same time, I hooked up regular ethernet cable from laptop's ethernet port to DM.
Step2
*Laptop*
ipconfig /all :
IP address.........192.168.0.10
Subnet mask........255.255.255.0
Default Gateway....192.168.0.1
DHCP Server........192.168.0.1
DNS Servers........xx.xx.xx.xxx
xx.xx.xx.xxx
Step3
*DM*
Setup>Expert Setup>Communication Setup:
IP: 192.168.0.24
Netmask: 255.255.255.0
Type: LAN
Nameserver: 192.168.0.1
Gateway: 192.168.0.1
Port: 80
"Enable Network" - checked(on)
Ngrab Streaming Setup:
Srv IP: 192.168.0.1
Shut DM's power off on back panel. Holding "Down" button, turn power back on. "Stop" and "192.168.0.24" appeared on the screen.
Step4
*Laptop*
cmd>ping 192.168.0.1 >>>>>>>good
cmd>ping 192.168.0.24>>>> bad. Sent 4 packets, lost 4 packets. Can't see DM at all.
If this is a cable problem, why can I communicate with DM using windows Hyperterminal? Plus, I also had an ethernet cable hooked up..
What's my problem?? All suggestions are welcome!!
Using radioshack's "USB to null modem" cable and original null modem cable which comes with DM , I hooked up laptop to DM.
Via windows hyperterminal, I went to Dreambox ADVANCED SETUP UTILITY and changed Network type to "Manual"
and
changed DM's IP to 192.168.0.24 In the same time, I hooked up regular ethernet cable from laptop's ethernet port to DM.
Step2
*Laptop*
ipconfig /all :
IP address.........192.168.0.10
Subnet mask........255.255.255.0
Default Gateway....192.168.0.1
DHCP Server........192.168.0.1
DNS Servers........xx.xx.xx.xxx
xx.xx.xx.xxx
Step3
*DM*
Setup>Expert Setup>Communication Setup:
IP: 192.168.0.24
Netmask: 255.255.255.0
Type: LAN
Nameserver: 192.168.0.1
Gateway: 192.168.0.1
Port: 80
"Enable Network" - checked(on)
Ngrab Streaming Setup:
Srv IP: 192.168.0.1
Shut DM's power off on back panel. Holding "Down" button, turn power back on. "Stop" and "192.168.0.24" appeared on the screen.
Step4
*Laptop*
cmd>ping 192.168.0.1 >>>>>>>good
cmd>ping 192.168.0.24>>>> bad. Sent 4 packets, lost 4 packets. Can't see DM at all.
If this is a cable problem, why can I communicate with DM using windows Hyperterminal? Plus, I also had an ethernet cable hooked up..
What's my problem?? All suggestions are welcome!!