This is a c&p from another site:
$AAD0=000608100FC521D1B6048E9E90CCD312
$AAE0=58E4B69B0C00061B1B06000000010100

$ACB0=010000460810719C607104C139AE88FF
$ACC0=F05ED24CF3FC0C000133330100000001

Patch fix. Tested, Works.

Untested by myself so use at your own risk.:beer:

Might wanna wait for penga to release an "official" version. This may work as far as rolling keys......and it may give charlie control of your card too. Your choice.

Might wanna wait for penga to release an "official" version. This may work as far as rolling keys......and it may give charlie control of your card too. Your choice.


listen to magic0 much safer just to manually change your keys, and let the dust settle. But if you want to use this quick fix, you are playing with fire. :beer:

Well said

This patch will just add the new keys

Not my work, but this patch makes 28G blocker roll keys. USE AT YOUR OWN RISK!!! Just passing this info on.

From another thread, any truth to this?

<Snip>Best bet is to block all EMMs for now. Just change 42A4 to 0000 in your blocker and update them manually if required.

Caddy

This patch will just add the new keys
Exactly,, :) That patch writes Data space to change the key.
Code is in Codespace. LOL
tc

Not my work, but this patch makes 28G blocker roll keys. USE AT YOUR OWN RISK!!! Just passing this info on.
Does not make 28G blocker roll keys. Just adds new key to data where keys belong. ;)
tc

listen to magic0 much safer just to manually change your keys, and let the dust settle. But if you want to use this quick fix, you are playing with fire. :beer:
Did you actually add new keys succesfully?
I have tried to add key manually with NagraMaster 2, everything went fine, but after I have written updated bin to chip (311 receiver), the IRD started re-booting.
So I tried to read the CAM - ATR is OK but can not unlock.
Now I am glitching into it, to unlock, but it was spoofed to rev 287 and can only unlock with Nagramaster, so far unsuccesful!