I am reading, just wanted to make an initial post. I don't expect to completely spoofed, but am hoping someone is generous enough to give me a nibble while begin my trek :)

I have a mounted DishPro dish from a recently DN setup.

This is my first FTA receiver.

Are there any walk throughs on what sat's to select in setup, the LNB type for the Dishpro, etc?

I think I can figure the programming out once I can find the right tools.

Did you get setup? Have same situation.

I'm assuming you are locked on signal and you have DishPro lnb's, they will be stamped with a DP logo. Now is there two or four hookups on the lnb? If there are four it is a DP quad lnb and you would use port one (119 side) and port three (110 side). If there are two ports this is a DP dual lnb one wire from the 119 side and one wire from the 110 side. If this is the case you can follow setups in this link http://forums.dsstester.com/vbb/showthread.php?t=55296 Now I am using a DP34 switch and another dish so you would just setup for the first two and assign the same configuration to your diseqc switch. Hope it helps!