I loaded the NORW_120 file to my STB. In dish settings, the ID banner in the upper right corner does not match my satelite. My satelite is 119.0 W Echostar 7, uppr right corner banner shows Echo star 110.
I followed PROGRAMMING COOLSAT FOR DUMMIES By Kuzco-version 1.0.
My settings are exactly the same as figure 11 of the instructions by Kuzco.
I also tried changing the committed and LNB type to no avail.
I only have one dish which goes to one tv only.
The dish is working properly, because I use my Viewsat with no problems.
Can anyone help me please.
Do I need to give more info?
Disregard, it is working perfect. Thanks to "PROGRAMMING COOLSAT FOR DUMMIES" by KUZCO :hat: :hat: :)

what version stb you had on previously, did you have this problem. if you dont remember try an earlier stb again and check the settings again, this will help detrmine if it is the stb_120 or the switch setting, because the receiver gives you the correct sat you are on whether you have the correct switch setting or not.

It is running perfect now. Thank you again.
It worked out perfect using "Programming Coolsat for Dummies" BY Kuzco.
Thank you very much Kuzco.
All I needed to do was scan and wait a few minutes. I left it on and went to walk my dog. When I came back, "WALA" the tv was on.