When I run Rebelserf 102 omniunlocker force fubar.xvb on my 102 card I get the following responce.
Rst0A !!!!!!!

******* Good response received! *********
90
===========================================
90 was hit at: Delay:03C0 VCC:0A GlitchType:06
Elapsed: 00:00:01
VCC Resolution: 0.5
Delay Range: 03C0 to 0420

********************************
* 102 CAM REVIVED!!! *
* READ THE CARD *
* CLEAN CODESPACE AND *
* WRITE CLEANED BIN TO CARD *
* GOOD LUCK! :-) *
********************************
However when I try to read the card in N2EDIT Beta 9 all I get is unable to read after 20 tries.

When I use New.xvb I get this

===========================================
Glitch Success!! A0FF-INTERCEPT IS ON
BootLoader 6F 00 RSP Received!!
VCC = 08 (~0.156862745098039 vdc)
Glitch Delay = 0323
Glitch type 07
===========================================

When I try to read the card with rom 10x reader writer unlocker I get this reply Eeprom read failed, AOFF intercept is not installed.

I am sorry for rambling it's the result of many hours of frustration!!!

false glitchen~! trim down vcc settens an try again! have had couple do this to me, they will finally pop!

i think the rebel file is only used to repair cams with unknown provider after unlocking with the 106-107 unlocking script,,must unlock with that first.

Thanks for the fast reply have not quite been able to figure out how to adjust any settings!!

i think the rebel file is only used to repair cams with unknown provider after unlocking with the 106-107 unlocking script,,must unlock with that first.

Thanks, Can you point me to the 106-107 unlocking script. I am using a Mikobu N2 and Winexplorer 5.42 if that helps:rolleyes:

I wouldnt mess with that new unlocker. It isnt working real well and it will mark your cards which may be a future target for the Dish Guys....

I wouldnt mess with that new unlocker. It isnt working real well and it will mark your cards which may be a future target for the Dish Guys....

Thanks!! Any suggestions on what to use to get back into this *&%^$( card:cry:

It wont be long....something will be out soon