just got this captiveworks cw600 and am having trouble flashing it. it will go to d000 but then goes almost immediately to E028 and sits there. can someone plase give me a hand and expalin what it is that is happening and possible solutions to cure it?

I don't have CW-600, but this is what I found





1. Turn Unit off with power switch on back of unit.

2. hold in power button on front of unit.

3. Turn unit on with rear power swtich.

4. The unit's display will read boot.

5. Load bin using Captive Works Loader version 1.04

6. When device display reads -END turn unit off with read power switch.

7. Turn device on with rear power switch.

8. Setup (if needed.)

Thread moved