Here's a picture of my cable that I created for my 2700-N2. Following the wiring diagram (http://forums.dsstester.com/vbb/showthread.php?t=41916) I used a cat5 cable attached to a DB25 pin , then attached that to a Hard Drive ribbon cable to connect to the jtag header. I soldered the 100 ohm resistors directly to the 25 pin connector. Very bushleague, but it works.

I hope this helps. If somebody wanted any other help, I be glad to share the very little I know :)

ps. if you are wondering, yes that is a disconnected wire. One of the wires popped of when I was stripping the electrical tape off everything.

good job, i've yet to get mine to work. we have the same receiver.

Here's a picture of my cable that I created for my 2700-N2. Following the wiring diagram (http://forums.dsstester.com/vbb/showthread.php?t=41916) I used a cat5 cable attached to a DB25 pin , then attached that to a Hard Drive ribbon cable to connect to the jtag header. I soldered the 100 ohm resistors directly to the 25 pin connector. Very bushleague, but it works.

I hope this helps. If somebody wanted any other help, I be glad to share the very little I know :)

ps. if you are wondering, yes that is a disconnected wire. One of the wires popped of when I was stripping the electrical tape off everything.

great job bud hope i can see the light too soon lol your pic has realy help me understand :beer: :beer:

can you say oklahoma credit card ( 6 ft piece a garden hose and a 5gal fuel can) ?? dude that cable is modern enginuity at its finest... where there is a will there is a way!

good job ! glad you got your unit back up an running

lol too funny ,but glad ya got it to work