When I do I Channel scan, it fails to scan the first half of the TP so I'm missing ~half of the channels. Also I get 2 of each channels. I'm running an Ariza 700 with the new 268 program. (I also have running a Pansat with no problems at all on the same dish).

Is there a way to fix this ?

Thanks

Mel

Yea! with bin 268, also when scanning a second bird, (using two dishes, 110 first, 91 second, with switches ans so on..) the first one stays listed but turns scrambled, while the second one power scans ok and shows all channels and shows just fine. Any suggestions? Bin 267 did not have this problem but had the loop problem, that is why I changed.

Yea! with bin 268, also when scanning a second bird, (using two dishes, 110 first, 91 second, with switches ans so on..) the first one stays listed but turns scrambled, while the second one power scans ok and shows all channels and shows just fine. Any suggestions? Bin 267 did not have this problem but had the loop problem, that is why I changed.
Dumb ques. but what do you mean by looping.thanx

Ok, I figured it out. Instead of having my LNB at standard it was at Universal 1. So I deleted all channels, did a scan and bingo I have all channels and only once.
Hope this help you tocolillo.

Mel

Good, and in my case I think the switches might have something to do with it

I don't mean to be a pest, i just want to know what you guys men't by looping.
Is that constant roll or what?
Thanx.
Or should i say loop.

Looping: (computer science) executing the same set of instructions a given number of times or until a specified result is obtained

Looping: (computer science) executing the same set of instructions a given number of times or until a specified result is obtained
thanx.