just set factory defalt,did channel scan ,put the new codes in 00 =9e 5b 7a 77 c0 fe 91 ca and in 01 = 4d 2a dc 33 d4 cd e3 75 saved in 001 dishnet ,what i'm i doing wrong ...thanks pjb1966@nbnet.nb.ca

make sure you are entering the keycodes in nagra2 not nagra1 screens, if that does not work go through the big checklist, make sure you are getting signal/quality, this will tell you if your dish is pointed properly, and if your switch between lnb's is working, go into your setup screens and make sure your EMU is set to on, make sure your key code is current. You could be in poor weather, or a poor dishshot. Look through this forum and troubleshoot. I found myself after initially programming with the factory flash and new bin file then entering current keycodes, making sure emu is turned on, and receiving signal that I needed to unplug my unit to activate the keycodes even though it was saved.

if you reset to factory defaults, you are going to have to load in the latest bin. ftacentral will have the files you need, once you have done that, you will have to set the emu to default and then channel scan.

Iteresting posts here. I can't see any channels and I tried everything i found in the forums. I would like to know only one thing: by using one of the maual key entry bins , how do I manually enter the keys.
I tried the suggestions by other posts and nothing worked so far.

Back to 267 and works perfect