Well i finally get to program my 301-013 single tsop but but only get picture on the preview channel no sound, for the others neither sound nor picture only program guide. Can someone tells what am i doing wrong? i guess i try every guide on this site.

you might miss-out some steps during the processing...I got the same situation with my 2XXX model..forgot to program the eerprom files..recheck..redo the steps..it should work out...also check to make sure you got the rite tsop load..

I don't know i must have try everything now. I know the procedure is correct,i modify the tsop and eeprom with data from my original tsop. The tsop files i have are said to be working from this site, any other suggestion?

Maybe try this thread: http://forums.dsstester.com/vbb/showthread.php?t=42359

I had the same problem very frustrating I knew I was close. I think when using flashedit I would change the build config and build data if necessary then I was hitting apply script. The last time I just used "save as" I also did write flash on atmega 1st then write eeprom on atmega 2nd. Dont know if this helps but thats what I remember the last things I did different. Hope i can pass it on. THE ABOVE LINK IS THE INSTRUCTIONS I USED ALONG WITH THE 2 PART ATMEGA WRITE

thanks but i tried the link over and over but nothing new. I replace all the data iin the build data area but still nothing . Whenever i select channel 500 i get sond temporarily and thats it, the closest. Just program no picture and audio. I am really frustrated. Any other help?

Are you doing a full erase first?? Also, are you using JKEYS to write both TSOP and EEPROM??

Yes i did a full erase 3 times then load the edited tsop and eeprom using jeepers. What i notice when i check the signal i get the beep sound initially and and then its stop. This morning to put in my atmega in with the jumper in the program mode, did a signal check and beep sound was continuous for the first time, but then it display "card not inserted correctly" so there was not enough time to see if channels would be display. The procedure is very easy but seems am not going to get my 301-013 working.

Am still not getting any sound or video on my 301-013 single, try it all over again. I get some sound after inserting my atmega with jumper in program mode and did the signal check but shortly after error message "smartcard not inserted correctly". Can anyone here confirm they are running on a dp301-013 single and what files are you using?