Okay, here's what happened to digi7000
I programmed the latesed file to the digi ran it and ran good over night
i left it on the table and pluged in my viewsat for a bit
My son was drinking water and spilled it right on top of the reciever so i was helpless i thought
I dried it off and pluged it in and said channel 162 and then went to error 0
i tried and tried and finally gave up and tried to reprogram it and downloaded alright but went to write to stb and connection failed and went to boot mode
Just says Boot, no dashes or anything at all on the front panel just boot
is my reciever fried do you think
i have tried the on and off trick, reciever to reciever transfer, and no luck
r055, 13.3 jump and no luck at all
i haven't tried to jtag but if there are any other possible ways to get this digi going i would appreciate any solutions offered
thanks

What versionof ftlinc did you try and did you use option 4. Try the same thing again but with version 3.1. ANd as it is saying connecting flip the back switch off then on.