Hi there,

I am a newbie to the FTA scene, but I have done a lot research on the topic. Here is my setup:

One dish with two LNB pointing at 110, 119 (I used an FTA disQec.)
Pansat 3500S

First I used GTLoader 3.36 and I loaded the new Pansat 3500S_051108_120_api(N).

Then I made sure that my settings were correct for each lnb. I pretty positive that my settings are right as I get level, quality signals around 75% for both.

Then I made sure that I selected "set default key". Did a blind scan afterwards and most channels came up.

However, when I try to view a channel it says "Bad channel or Scrabbled". I was wondering if anyone could provide any suggestions. Thank-you in advanced.

Hi there,

I am a newbie to the FTA scene, but I have done a lot research on the topic. Here is my setup:

One dish with two LNB pointing at 110, 119 (I used an FTA disQec.)
Pansat 3500S

First I used GTLoader 3.36 and I loaded the new Pansat 3500S_051108_120_api(N).

Then I made sure that my settings were correct for each lnb. I pretty positive that my settings are right as I get level, quality signals around 75% for both.

Then I made sure that I selected "set default key". Did a blind scan afterwards and most channels came up.

However, when I try to view a channel it says "Bad channel or Scrabbled". I was wondering if anyone could provide any suggestions. Thank-you in advanced.

You set up were good, just have to double check the sat signal make sue they both are good.

Some time when you do scan for satellite, the channel are double, for example

If you check on the channel list you will find there are double channel, and one of the channels will give BAD or SCRAMBLR CHANNEL, so you have to delete the bad channel out.

The best way is to use the Channel Master to edit, and you can found that in the file down load section