c / p from another place
USE AT YOUR OWN RISK
simple jtag

--------------------------------------------------------------------------------

Simple jtag works good, keep the wires very short.
Pads for JP202 next to the xtal are pins115 from the
sti5518 and ground. You can either just ground the left
pad at powerup, or solder in 2 posts and use a standard
jumper to put the micro into bfr mode to erase/write the
flash. Use 100 ohm resistors and a male db25 connector.
http://i30.photobucket.com/albums/c311/skunkerbudd/20pinsimplejtag.jpg
http://i30.photobucket.com/albums/c311/skunkerbudd/20pinjtag.jpg