|
View Full Version : Digiwave 7000 problem! Help ! FaCkEnBaSsTaRd 10-13-2005, 06:02 PM Programing went fine. Flash went fine. Channel search went fine. BUT, when I go to watch TV is says: 1-no signal 2-scrambled 3-updating...and never stops ! Mas 10-13-2005, 06:52 PM Programing went fine. Flash went fine. Channel search went fine. BUT, when I go to watch TV is says: 1-no signal 2-scrambled 3-updating...and never stops ! You already answer on own question, See #1. Make sure you dish is aim to dishnet 110 or 119, also make you get good quality level. Some time you get a good signal strenge, but it could be wrong satellite. THADEADMAN 10-13-2005, 09:35 PM Programing went fine. Flash went fine. Channel search went fine. BUT, when I go to watch TV is says: 1-no signal 2-scrambled 3-updating...and never stops ! make sure the dish is aimed right an check your disque switch settings i find with that box an most have 119 on port A and 110 on port B jampru1 11-20-2005, 05:41 PM I have a 7000 digiwave . I CAN NOT get any of the channels from 1 thru 10 is it because of the low transponders argos996 11-20-2005, 07:21 PM Your channel 1 thru 10 can be completely differn't then someone elses. Depends on what channel list your using if you did a sat scan what sats you can get. when you tune to the channel it will tell you what sat it is on and what transponder. Then use that info and check your sat strength and quality in antenna settings. If your strength and quality are high then it maybe due to channel moved so a rescan is needed. Or if it is a music channel last time I checked you couldn't get the pay music channels with digiwave. haven't tried the newest bin yet. |