Has anyone got the mcgar200 working. I program the board with the 200.hex and eep files but when I try to run mcgar200 the board resets ok but I don't have the 64 value where it is supposed to be I have checked my settings and they are as the instructions say I also get prompted for a password which is supposed to be Anything you want! but that nor anything I tried has worked. Any help out there sure would appreciated anything that is suggested.

if you download jeepers1.2.1 problem solved

I have taken your advise and downloaded Jeepers 1.2.1. Couple of questions. Do you have it working. Did you change the lead from pin 9 to pin 13 on your avr or is this necessary? Did you use fbprg16 to load and program the hex. and eep. files. Did you get any error messages in address 0000 when you programmed the board. With jeepers apparently I don't need to run mcgar200 in my ISO programmer. Any help would be appreciated.null

Archer, I am assuming the reason you are using mcgar200 is for the autoroll. The way I get jeepers top work for me is to program the external chip first. From the menu bar select I2C EEPROM -> write areep200.
Then I select married sub for enabler type, enter the rest of the information in the required fields and then do a full monty.
Make sure you have the correct public key in the cam section or will end up with a full menu but just a blank screen.