Pooh
11-23-2001, 07:42 PM
Hi,
I have a question on programming the 24LC256 serial eeprom. The instructions says to use Winexplorer, but that's a serial ISO programmer program. Do I have to make up the serial interface to the 24LC256 and program that first before I hook it up to my AVR?
Also, funprom is used to program the hex and eep to the Atmel, but it says to use eepedit to edit the ird and cam info. Presumably, after I've used funprom to load eep provided, I then use eepedit to write the eeprom values out again? Thanks!
I have a question on programming the 24LC256 serial eeprom. The instructions says to use Winexplorer, but that's a serial ISO programmer program. Do I have to make up the serial interface to the 24LC256 and program that first before I hook it up to my AVR?
Also, funprom is used to program the hex and eep to the Atmel, but it says to use eepedit to edit the ird and cam info. Presumably, after I've used funprom to load eep provided, I then use eepedit to write the eeprom values out again? Thanks!