:(
I am still a newbie to FTA. Just got one almost 2 weeks, now.
Problems I encountered:
I get good signal and quality of 110, 119 and BEV, which I think I got the birds. But I only received 110, and get bad or scrambled messages on 119 and BEV.
I did almost everything that I read in the forum.
Factory Reset the IRD; Flash with Factory Bin and downloaded the latest fix available( I tried the 040916.235, and then the 041001.236 and lately the 041004.236). I downloaded various Channel List, set EMU on and set default system. LNB freq. to 11250 and Spacelab diseqc switch respectively to each LNB. Dish500 dish with twin LNB for DN and DTV dish for the BEV.
Please , I really need your expert help and guidance. I have been reading almost all the topics in the forum, even before I bought the Pansat 2500a.
I tried almost everything I read in the forum, but still no 119 and BEV.
Please advice if I there are still somethings I have to do with the IRD settings or with the diseqc switch or with the Dish pointing.
Thanks a lot for any tip you might have.

:(
I am still a newbie to FTA. Just got one almost 2 weeks, now.
Problems I encountered:
I get good signal and quality of 110, 119 and BEV, which I think I got the birds. But I only received 110, and get bad or scrambled messages on 119 and BEV.
I did almost everything that I read in the forum.
Factory Reset the IRD; Flash with Factory Bin and downloaded the latest fix available( I tried the 040916.235, and then the 041001.236 and lately the 041004.236). I downloaded various Channel List, set EMU on and set default system. LNB freq. to 11250 and Spacelab diseqc switch respectively to each LNB. Dish500 dish with twin LNB for DN and DTV dish for the BEV.
Please , I really need your expert help and guidance. I have been reading almost all the topics in the forum, even before I bought the Pansat 2500a.
I tried almost everything I read in the forum, but still no 119 and BEV.
Please advice if I there are still somethings I have to do with the IRD settings or with the diseqc switch or with the Dish pointing.
Thanks a lot for any tip you might have.
Are you getting any transponders on the 119 or BEV at the 91 in the blind scan mode? It will show you "0 transponders" immediately if it is not catching a bird. I am assuming so since you are getting a bad or scrambled mess. on the channels. I would check again with a signal meter and compass then try another blind scan. I have used the default settings on the 119 and 91 without problems. If you are getting the 110, your bin and other settings are probably correct. Success to you. :beer: Tweak it around. That has meant gaining 5 transponders at times. :wow: