Guys, I did do AVR search prior to asking these questions. I was told all I needed was AVR and programmer to watch tv. I now have this as well as a 2700 ird. Have dual lnb Dishpro set up. Is there a newbie guide and files for the AVR. I hope I wasn't lied to and need other thing to watch tv. Can someone clarify. :(

how to update AVR with SUB.

Ok starting from the beginning

1. Put your sub card in IRD, till you get all video/sound. This will update you sub card, with a new active publick key.

2. Open Jeeper, fill in all the information, with the later key:

For exsample
ExpressVU AUX 0 is active,
AUX0 20 85 FD 1F A0 C7 48 62 Active
AUX1 65 57 46 14 36 02 D8 DA

3. Put Aux0 in the public key box, and mark DOT in Aux 0

4. Make sure all the information are correct, then full monty. When it complate, don't close the Jeeper yet, put card and avr together, then put in IRD, make sure it working, get all the channels(video/sound)

5. If it working then back to Jeeper Save the AVR configuration, and name it.

For next time when Bev changed the new key, all you have to do:

a) Open the Jeeper, load the Avr configuration you had save from #5.

b) update new key, Hit GET to to update with the new key. NOT NEED TO CHNAGE THE PUBLIC KEY, and hit write, and Watching TV.

*** PS *** If you put the sub card back in the IRD, then you have to change the public key.

p.s . most well written files have jeepers included for easy application

i have an ex subbed card witha an avr 369 on a 2700 that does not match the card how can i get this to work?

in jeepers select exsubbed or no cam if you have the boxkeys ,for ex sub put in any valid cam or you can use s000012345678