I have a question for everyone. What prog can I use to read the data written to my Atmega128. I have a good wide open progam written to it and I want to read and save if possible or modify it. Any help would be appreciated. :hat:

iduno u use jeepers to write ?
why not just write a new one as needed?
i honestly have no idea if / when u find out
let me know and remember dont give up and
helpsomeone else when you can

hope this helped

I have a question for everyone. What prog can I use to read the data written to my Atmega128. I have a good wide open progam written to it and I want to read and save if possible or modify it. Any help would be appreciated. :hat:

why you have to read from the atmega? If you program the atmega, you should have the PFG file. I not sure it will work or not, but there are 2 ways you can try:

1. Open the Jeeper, then ACTION>Read EEPROM/Config, then save it

2. Open the Jeeper, then ATMEL>Atmega_128>Read EEPROM, then save it