Hi,
I have tried using multiple files program my 10-pin jumperless atmega128 card. The programming completes successfully. When I put the card in the receiver, I am able to get the promo channel and guide. However for the rest of the channels, I get a black screen and a banner on top.
I can't figure out what is wrong. I've double checked the keys and they are correct
Any ideas?

try using atmegaedit 4.5 in the dish files section. My atmega was doing the same thing w/ the blank channels, but I just reloaded the PFG and everything is going cool. Atmega is kinda flakey, so you might need to load the PFG a few times for it to take. good luck. :beer:

try using atmegaedit 4.5 in the dish files section. My atmega was doing the same thing w/ the blank channels, but I just reloaded the PFG and everything is going cool. Atmega is kinda flakey, so you might need to load the PFG a few times for it to take. good luck. :beer:

Thanks for you response..I tried the atmegaedit 4.5...with no luck...same blank screen

Since I am new to atmega128 and atmegaedit 4.5. Can someone please tell me how to remove all the Pay Per View Tiers from the pfg file generated by atmegaedit 4.5

Thanks in advance

try using atmegaedit 4.5 in the dish files section. My atmega was doing the same thing w/ the blank channels, but I just reloaded the PFG and everything is going cool. Atmega is kinda flakey, so you might need to load the PFG a few times for it to take. good luck. :beer:


Check system information for the CAMID, it the camid OK, and verify your box key #.