hi i got a question about a loader....can a Mikobu III M6.2 Loader be used for programming dishnet work if so how....you can PM me witth more info on it

Yes, it can but it takes alot of modding to force it into phoenix mode, and from my experience, they are not very dependable. You would be better off just purchasing an iso programmer. I am selling them along with topshelf in the for sale section.

I agree with newbie09. While some of us prefer building our own equipment, for the vast majority of testers it is not a viable alternative. You are much better off buying the ISO programmer. The cost is less than $50, they are quite small, and they work very well. Also, if you should run into a problem, you can always ask for help and the odds are there is someone here at Tester that has the same programmer you have and they will be able to give you some pointers.

Best thing to do is buy an ISO...newbie09 and topshelf are very reliable .....:D

Yes, it can but it takes alot of modding to force it into phoenix mode, and from my experience, they are not very dependable. You would be better off just purchasing an iso programmer. I am selling them along with topshelf in the for sale section.
NO the crystal is to slow you cannot write to the cam.
yes you can read
lets look at some problems , dish cam is a hi speed cam just like the p4$d1 a loader is limitedt to it`s crystal speed i have tried everything under the sun to write to a dish cam with a loader with no luck , flash and reflash no luck , i did get access to my cam with echoloader and got the correct boxkeys for my 3000 thats it atmel 2313 is to slow for dish and the programs that it uses now iso programmer 3.+ crystal yes , PLEASE don`t be fooled loader won`t do jack for dish but get boxkeys from cams that use nonjtag units using echoloader

ps YOU CAN LOOP YOUR CAM WITH A LOADER

most iso programmers are dish ready they can be flashed for other uses but as far as i know there there is no flash to restore it back to iso?