Here is a dumb question:

I read the newbies section and since didn't find an answer, here it is:

Can I use an ISO loader (DTV) (with DishNet software and files of course)to program DishNet?

You need a ISO program to read & write dish rom card, not DTV loader.

Check the crystal on your iso programmer, you need it to say 3.67 if not then it wont work unless you replace that crystal, which I have done by ordering a new crystal at digikey.com for less then a $1, not including shipping, but you need this part number:

300-6002-ND Crystal 3.6864 MhZ HC49/US

Here is a dumb question:

I read the newbies section and since didn't find an answer, here it is:

Can I use an ISO loader (DTV) (with DishNet software and files of course)to program DishNet?

People are going to find this a bit unusual but I have a home made ISO loader that was set up for DTV emulation. Not long ago I just stuck one of my dish cards into it and tried nagra edit. I dumped the cards Eeprom. Then I tried loading the card and it worked just fine. Huh.. Been using it ever since..
I dont know if it will work for you or not