I can read and back-up my bin fine using the ISO MIKOBU for my open ROM10..But when I go to 1 step clean before writing the new script on to the card...I get this error after it read my IRD#, CAMID#, BD Keys#, login verified, and then it error out with 'disabling card' and 'error detected, Writing ROM10 incomplele'..

Does someone has any idea what going on? Did I screw something up..I am using NagraEdit 3 and the ROM10 is at REV A16...Tks in advance...:no:

SEE WHAT BLOCKER YOU PUT ON THE CARD IF YOUR USING THE NEWEST ONE MAKE SHORE YOU KNOW THE BACK DOOR KEYS OR YOUR LOCKED OUT...GOODLUCK

HAPPY HACKING:D

keep trying it....I had a couple that were very stubborn.... if writing a clean bin back to the card doesn't fix it then i'd say something else was wrong.... card communications or something

The writing process went always to the end after it wrote to code space and data space..and right at 'enabling card'..it stop and gave me Writing ROM10 fail error.

I read the card and it look like it wrote the script since it put a new backdoor password and change my local byte..I am using NEActCloneR10 script...Can I assume that it complete the writing process..

I don't want to test the data stream yet if the writing process is not complete or the backdoor password is not in place..

Tks again:)

can you dump the card with your password? or does it try the BD0 attempt first?

if you are able to dump your bin, look at $C600: if all zero's then I believe no blocker has been applied....


If the card prompts for a password then most likely it wrote, I'm not familiar with the script your using, but i imagine it uses the same blocker(NBC)

I checked the EEPROM dump and at $C600, it did write the backdoor password to it...So I went a head and test the data stream and it works..I am watching CHARLIE for the first time.

It obviously wrote the 3M and the backdoor password, I am hoping it wrote the blocker script too..Yes, I am using NBC script. I am just curious why NE3 didn't say the writing process complete eventhough it did...

Thanks again for your info...:) :yes: :)