Hi guys,I have a problem with Cs7100.The message says I do not have enough space.I can not change channels,it goes back to channel 100,and the message says SYSTEM-Not enough space.Anyone have a clue,as to whats going on.Thanks for any help.

May get a better response in the CS forum.

You may have installed many new bins and did rescans without factory defaulting. It is not a bad idea to do a factory default every once in a while to clean out any garbage. Don't forget, it is just a processor and memory so it may have some file fragments left from previous bins and scans.

i moved your thread to the cs section,i assume it is a 7100 pvr?.i can tell you that when my sv4000 displays a message as no memory it useually requires a factory default and the load the factory bin and new bin,that corrects the problem,maybe you need to do the same for your cs,let me know if i placed your thread in the right area,also if it is a pvr is the hard drive full?

Hi guys,I have a problem with Cs7100.The message says I do not have enough space.I can not change channels,it goes back to channel 100,and the message says SYSTEM-Not enough space.Anyone have a clue,as to whats going on.Thanks for any help.

You might need to do a factory reset, then rescan to fix this. I think you might have accidently tried to record something.
I've done this(thought it was messed up)It can't record unless you have an external space
Hope that explains it

I think hes tring to record channel 100. erase the mem. stick. put it back in 7100, then stop recording. Good Luck !