Steps for FLU and Pansat 2500 to 2700 B-7-5 via Serial Cable Com 1

I myself did it this way I converted to B-7-5 is very simple my Fotec Lifetime Ultra Reciever had the 293T bin installed just follow the following steps:


1. Write down all settings from your receiver save channel with Channel Master, or GTools and save your Channel List

2. Open Blacklist Updater 1.4 Loader

3. Click on Select Bin look for j27_205_1.bin (This is the original,there may be newer versions that can do the B-75 Upgrade)

4. Turn OFF receiver from rear switch.

5. Turn ON receiver from rear switch.

6. On 1st dash on front display select Write Bin

7. WAIT 2-3 Min! Do Not Touch PC or reciever at this point the loader on PC will get done, but the reciever will freeze on the last dash, Let it Finish! It will reboot with B-7-5 twice and freeze on the 5 finally with "ON" in the display.

8. Turn OFF receiver from rear switch

9. Change BIN from j27_205_1.bin to the jvvh_208_1.bin(or newest bin converted for converted boxes) in loader software.

10. Turn ON receiver from rear switch

11. On first "B" on front display select Write Bin

12. Wait till you see ON before doing anything

13. Load the latest B-7-5 Bin's You can use the CS Lightning series Bin's and Jvvh as long is not PUFF you should be Ok.

Thanks to those that made this possible

This is a Copy, Paste and personally Edited Instruction.