HI, My first attempt at this, so hope I am doing correctly.
I cannot upgrade my receiver after SP6026. I load the new files on a USB 2.0
Flash Drive but my receiver does:) not recognize the USB. I tried a new Flash
Drive, but it didn't help. If anyone else has had this problem or knows a
solution, I would appreciate any help. Thanks

yes I did, it was a ID 10 T error, {idiot} I thought the usb flash was pushed in all the way, but it was not. I receive the light but the unit did not recongnized the usb stick. I now sometimes have that problem, I just slightly move the stick up and down and maybe a little to right or left and booyahow I see the light turn red on the screen and the it sees the usb. Hope this helps. By the way have you tired to set it back to fac default and the update bin file??

I had the same problem then tried a few different USB drives and found that the PNY Attache' works well.


Neusat SP-6000-Premium

HI, My first attempt at this, so hope I am doing correctly.
I cannot upgrade my receiver after SP6026. I load the new files on a USB 2.0
Flash Drive but my receiver does:) not recognize the USB. I tried a new Flash
Drive, but it didn't help. If anyone else has had this problem or knows a
solution, I would appreciate any help. Thanks

Probably going to have to load the factory bin on it to get it to see the usb drive....had that happen once.....loaded the factory bin back on then it would see the usb OK...
Make sure the file is unzipped/unrar'd first onto the usb....and you should be good to go again....>)